Step 1: Replace of Heavily Damaged Asphalt
With your approval, any areas that are damaged beyond repair are saw cut, removed, and then be patched with new asphalt. These repairs will later be concealed by the sand mix sealer.
PATCH Replace Damaged Asphalt
Step 2: Edge & Clean
We thoroughly clean your asphalt surface and all grass is cut back beyond the asphalt in order to cover the entire pavement surface.
EDGE Edge & Clean
Step 3: Remove Debris
All grass is removed from the cracks and all sand, dirt, and grime are swept clean from your driveway.
SWEEP Remove Debris
Step 4: Prepare Surface for Adhesion
The entire surface is then blown off using a high-powered blower to ensure the sealer to will properly adhere to the asphalt.
PREPAREEntire Surface is Blown Clean
Step 5: Hot, Liquefied Crack Repair
All cracks are filled with hot, liquefied rubber, which is poured into the cracks at 400 degrees F is high temperature ensures better adherence to the existing asphalt and an overall cleaner look. All cracks are filled several times to ensure they sit flush with the pavement surface.
REPAIR Cracks Filled with Hot Rubber
Step 6: Sand Mix Seal Coat
The surface is coated with 1-2 coats of sand mix sealer applied with a squeegee to the surface to ensure a very neat job. We do not spray the seal coating on your asphalt surface because of the various problems associated with this application method including: peeling and messy overspray.
SEAL Applied by Squeegee